other

24C32 32K I2C EEPROM Memor DS1307 based RTC with LIR2032 battery (Battery not included) Backup by AT24C32 32Kbit DS1307,AT24C32 can work separated Leads to the DS1307 clock pin, to provide the clock...

  One Terminal Strip, Tie-point 25. Material: ABS plastic Completely reusable. Accepts a variety of wire sizes (29-20 AWG)...

Various flame, fire detection, relay output, which can be accessed 220V high current electrical equipment Module Features: 1, can detect the flame or the wavelength at 760 nm to 1100 nm range of...

Connect your prototype circuit to the Arduino easily with this simple to use Arduino shield. It includes a mini-breadboard with self-adhesive backing so you can stick this onto the shield and use it...

Operating Voltage : 5V(DC) Static Current: Less than 2mA. Output Signal: Electric frequency signal, high level 5V, low level 0V. Sensor Angle: Not more than 15 degrees Detection Distance: 2cm-450cm...

40 pin cable, 30cm in length. Cable type: female-female

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size. Works great, just carefully open the connector on...

Working voltage: DC5V-20V Quiescent Current: 65uA Level Output Voltage: High 3V / Low 0V Delaying time: 0.3~18s (adjustable) Blockade Time: 0.2s Trigger Method: L: unrepeatable trigger / H:...

Current Limiting resistor IMΩ +/- 5% Electro-scattering time 0.1 sec Safe and reliable Adjustable at will Rinsing resisting Suitable for use in clean rooms

This inexpensive USB to RS232 cable works well for Linux and Windows 7 environments, but is not currently functioning with Windows 10. Suitable for link download Simple and easy way to give USB...

This is a digital temperature and humidity sensor module that works with all of the Arduino micro-controllers. Because it is a digital sensor it only necessitates 3 connections, Vcc, GND, and a...

This is a very popular LCD for the Arduino or Freeduino board. It includes a 2×16 LCD display which is backlit in blue. It uses the I2C communications protocol so it is compatible with any...

This is a 5V, 10A 2-Channel Relay interface board. It can be used to control various appliances, and other equipments with large current. It can be controlled directly with 3.3V or 5V logic signals...

This is a motor shield for an Arduino Uno that makes it easy for your Arduino to control various types of motors! All you need to do is attach this to your Uno, run wires from your motors to the...

This is a digital temperature and humidity sensor module that works with all of the Arduino micro-controllers. Because it is a digital sensor it only necessitates 3 connections, Vcc, GND, and a...

This is an Arduino Compatible Ultrasonic sensor, it can be used to measure the distance from the sensor to other objects around it. These types of sensors are used on robots for collision avoidance...

L3G4200D is a 3 axis gyroscope, providing you with very high resolution (16 bit) measurements at up to 2000 degrees per second (dps).   The gyroscope measures how much the device is rotating...

IIC digital output Up to two interruption function Three motion detection channels: Free fall down or motion detection. Pulse detection Vibration detection MMA8452Q is a 12 bit resolution...

This is a lone infra-red sensor for use with an Arduino or Raspberry Pi. It can be used to decode infra-red signals from remote controls such as a TV remote or some RC vehicle remotes. It is...