Waveshare 24211 - USB Port High Definition HDMI Video Capture Card, For Gaming / Streaming / Cameras, HDMI To USB 3.0 - HDMI to USB3.0 Adapter Features 4K Input: 30Hz 1080P Output: @30Hz/60Hz USB Port: USB2.0/3.0...

If you need to connect a battery pack or wired power supply to a board that has a DC jack - this adapter will come in very handy! There is a 2.1mm DC plug on one end, and a screw terminal block on the other. The terminals are labeled with...

If you need to add a panel-mount connection for USB C, but don't have the time or tools to cut a custom oval or square hole, this USB C Jack to USB C Jack Round Panel Mount Plug is the easiest and fastest way to panel-ify your project. It's about 30mm in...

Allo - Set of DC 5.5 X 2.1mm Adapters Allo Nirvana & Shanti replacement adapters. Content 1 X DC 5.5 X 2.1mm Input to 5.5 X 2.5mm Output 1 X DC 5.5 X 2.1mm Input to 4.0 X 1.7mm Output 1 X DC 5.5 X 2.1mm Input to 4.8 X 1.7mm...

Waveshare 19134 - Compute Module DSI Display Adapter, 22PIN To 15PIN - CM-DSI-ADAPTER Features Compute Module DSI Display Adapter: 22PIN To 15PIN, Allowing The Compute Module To Use 15PIN DSI Displays Suitable For Compute Module IO Board:...

Waveshare 15817 - USB To RS232/485/TTL Interface Converter, Industrial Isolation This is an industrial USB to RS232/485/TTL isolated converter with original FT232RL inside. It features embedded protection circuits such as power isolation, ADI magnetical...

Multifunctional USB Power Meter - LCD Color Display - USB / Micro USB / USB-C A handy tool that measures voltage, current, power, charge time, and more for all of your USB A, Micro B, and USB C gadgets (phones, power banks, etc...) Features ...

Waveshare 21358 - USB-C Adapter For NGFF M.2 SSD, USB3.2 Gen2 Type-C Note that this adapter is ONLY for SATA M.2 SSDs. NVMe IS NOT supported! Features M.2 NGFF Protocol Support High-speed Transfer USB-C Connector: Transforming Your M.2 SSD Into...

The SparkFun Qwiic Adapter provides the perfect means to make any old I2C board into a Qwiic-enabled board. This adapter breaks out the I2C pins from the Qwiic connectors to pins that you can easily solder with your favorite I2C-enabled device. The Qwiic...

The adaptor allows the Raspberry Pi 4 to be used with a Pi USB-C power supply (or DC barrel jack) whilst allowing access to USB 2 OTG data over a separate USB-C connection (USB3 data is not connected/passed through). USB Type-C (DATA POWER) <> USB...

Waveshare 17939 - Industrial USB TO TTL Converter, Original FT232RL Onboard, Multi Protection Circuits, Multi Systems Support USB signal & Pinouts Definition 5V 5V output VCC 3.3V or 5V output, configured by...

USB 3.0 SuperSpeed adapters are a great way to quickly change the connection type or gender of an existing USB cable. This adapter has USB Type C Male opposite USB 3.0 Type A Female.  Features Connector A: USB Type C Male Connector B: USB...

Caution! This product is NOT compatible with the new Raspberry Pi Zero W 2 Using solderless pins the adapter slides onto the back of a Pi Zero GPIO (If a permanent connection is required the adapter can still be soldered to the GPIO header). The adapter...

USB Serial Adaptor Plugs directly onto our Cluster HAT and MMC (SD) HAT to provide serial console access to the Raspberry Pi for quick access. Using jumper wires it can be used to access the serial on a Raspberry Pi and for Arduino programming (using RTS...

This DC-DC 12V to 3.3V 5V 12V Power Module Multi Output Voltage Conversion is also known as Buck Converter or also as Step-Down Voltage Converter. The module is capable of altering the output of the power source/supply before...

Features: On-board MAX485 chip, A low power consumption for the RS-485 communication, slew-rate limited transceiver. On board then 5.08 (mm) pitch 2P terminal to facilitate RS-485 communication wiring. All pins of chip have been lead to can be...

Need more gigabytes on your Pi? Connect a SATA hard disk or SSD to your Raspberry Pi with this compact, high-performance USB 3.0 to SATA adapter. Great for storing media, games, data, or backing up your projects! This new version of our USB to...

USB Type-C to USB 2.0 Micro-B Adapter

This adapter allows you to use a 5.5 x 2.1mm DC power supply for a device that requires a 5.5 x 2.5mm power supply. Many of Allo's older audio boards feature the larger 2.5mm size, but their newer boards (2020) and Audio Power Supplies are all the more...

13860 - Mini HDMI to VGA Cable This is NOT compatible with Raspberry Pi Zero, Zero W, 3 & 4. This cable only works with the specific Waveshare displays listed below.  For Raspberry Pi 4, please see our Raspberry Pi 4 Micro HDMI to VGA adapter...