This is a really nice power supply. It's a switching DC supply so it's small and light and efficient. It is thin so it fits in power strips without blocking other outlets. The output is regulated so you'll get a steady 12V up to 1000mA (1 Amp) of current...

Waveshare 23884 - Uninterruptible Power Supply (UPS) Module, Supports Charging And Power Output At The Same Time, 3S & 5V 5A Output - UPS Module 3S (EN) This Uninterruptable Power Supply (UPS) module takes three 18650 lithium-ion...

Official Micro USB Power Supply - White - USThis new single-head micro USB power supply is suitable for use with the Raspberry Pi Zero 2 W, as well as the Raspberry Pi 1/1+/2/3/3+ models, and the original Raspberry Pi Zero and Zero W. Features ...

Raspberry Pi 48W Power Supply for Build HAT - White - US Power your Raspberry Pi Build HAT projects with the Raspberry Pi Build HAT Power Supply. This 48W power supply will power the Build HAT and connected LEGO® TechnicTM motors, as...

Power Supply 19V 3.4A, 65W - 5.5mmx2.5mmx12mm Barrel - For IQaudio DigiAMP+This high quality power adapter delivers a stable 19V @3.4A and features a 5.5 mm x 2.5 mm barrel connector making it perfect for the IQaudio DigiAMP+...

USB-C Power Supply - 5.1V 3.0A - UL Listed - Black - On/Off Switch - For Raspberry Pi 4/400This is a high quality switching ‘wall wart’ AC to DC 5.1V 3.0A USB-C wall power supply manufactured specifically for projects that require a higher...

Features Works with VOLT+ With Stepped Attenuator 60W, 3.15Amps DC Male Jack: 3mm x 6.5mm Audiophile low level noise / ripple Comes with the wall plug for your region (UK/US/EU) Support & Downloads CLICK HERE FOR AUDIO...

SPECS: Plug Type: Aus, Euro, US Input Voltage AC: 100V - 240V Output Voltage Nom. 5V Output Current Max: 3A Power Supply Output Type: Fixed Output Connector: USB Micro Cable Length : 45 inch

Specifications Input voltage: 100~240VAC / 50/60Hz Output voltage: 24V Output current: 3.3A Output connector: C14, 5.5mm*2.1mm*12mm, 1500mm AC cable: 1000mm Standards: UL

USB-C Power Supply - 5.1V 3.0A - UL Listed - Black - For Raspberry Pi 4B 1GB/2GB/4GBThis is a high quality switching ‘wall wart’ AC to DC 5.1V 3.0A USB-C wall power supply manufactured specifically for projects that require a higher level of...

The official Raspberry Pi USB-C power supply for the Raspberry Pi 4B. If the black power supply is out of stock, it still might be available in white. This 15W power supply features the USB-C connection found on the Raspberry Pi 4. It provides 3...

This is a beefy switching supply, for when you need a lot of power! It can supply 12V DC up to 5 Amps, running from 110V or 220V power (the plug it comes with is for US/Canada/Japan but you can use any plug adapter for your country, or just replace the...

These ultra-compact wired RAC03-SE/277 modules provide an output voltage of 5V, and the input-to-output isolation is 3kVAC/1min. With a standby consumption of 30mW typical, the mini power supplies are particularly suitable for energy-saving sleep mode...

The Texas Instruments TPS2113A autoswitching power multiplexer allows you to switch seamlessly between two power sources of 2.8 V to 5.5 V while blocking reverse current into either source. The power multiplexer (or mux) has an adjustable...

This is an inverter for EL wire and tape, similar to our pocket inverters, except it is a brick that takes 12V input instead of 2 AA batteries. This means its good for 'fixed' installations since you can just plug it into a 12V wall adapter. It's also...

Compatible with the JustBoom Amp HAT and JustBoom Amp Zero. This 60W to 65W 15v power supply has a 100-240VAC input and comes supplied complete with UK, European, USA and Australian pins as standard. This carries full international safety approvals...

The squarish board with two chips on it is the transmitter (power with 9V).  The longer board is the output and you can connect that to the part of your project that needs powering. Inductive charging is a way of powering a device without...

This 60W power supply is perfect for the HiFiBerry Amp+, JustBoom Amp, and many other applications. Specifications 18V output voltage 3.3A output current 2.1mm x 5.5mm x 12mm barrel jack output connector Accepts 100-240V input...

5V 2A USB power adapter is the perfect choice for powering single-board computers like Raspberry Pi, BeagleBone or anything else that's power hungry! This adapter was specifically designed to provide 5.25V not 5V, but we still call it a 5V USB adapter...

This is a really nice power supply. It's a switching DC supply so its small and light and efficient. It is thin so it fits in power strips without blocking other outlets. The output is regulated so you'll get a steady 9V up to 1000mA (1 Amp) of current...