other

This is a digital Tap/Knock sensor on a small circuit board that is designed to work with all of the Arduino boards. It is easy to incorporate into any project requiring only a 5v supply, ground, and...

This is a digital temperature sensor module that can be used with any Arduino board. It measures temperatures from -55°C to +125°C and outputs a digital signal that can be read using one...

We use these sets of 4 clear rubber feet on our HighPi case, but you'll find other uses for them too! 

Adhesive thermal layer Keep your Raspberry Pi cool with this heat sink Reduces the risk of hardware failure due to overheating Low profile, will fit into most cases Simple, passive cooling. no...

Handy for making wire harnesses or jumpering between headers on PCB's These premium jumper wires are 20cm long and come in a 'strip' of 40 0.1" male header contacts on one end and 0.1" female header...

Multicolored / comes in a 40-pin separable ribbon cable Great for microcontroller experiment

Mini 170 Tie Points Prototype Solderless Breadboard With self-adhesive tape Suitable for electronic circuit assembly / debugging / training A magic combination breadboard pattern of isolated tie...

6x AA Battery Holder with 2.1mm DC Connector and switch With a DC 2.1mm power jack which can plug directly into an Arduino Hold 6 x 1.2 (7.2V total) rechargeable NiMH / NiCd AA battery or 1.5 (9V...

This is a cute half-size breadboard, good for small projects. It's 2.2" x 3.4" (5.5 cm x 8.5 cm) with a standard double-strip in the middle and two power rails on both sides. You can pull the power...

PRO SIGNAL-RPUSB 1M-COMPUTER CABLE, USB A PLUG TO MICRO USB B PLUG, 1M, BLACK High quality standard A-miniB USB cable, for USB 1.1 or 2.0. Approximately 1M (3ft) long from end to end.