A slim, laser-cut acrylic case that turns your Pi Zero W and 1.3in LCD into a tidy pocket-sized gadget.
This two-plate acrylic case is made for the Raspberry Pi Zero W paired with the Waveshare 1.3in LCD display. The front plate frames the screen and the cutouts for the controls. The back plate covers the Pi and keeps the ports reachable. Everything bolts together with the included black hardware, so there’s no glue and no snap-fit tabs to break. You can open it up again whenever you want to swap an SD card or change your wiring.
Features
- Slim sandwich design: Two flat plates and short standoffs keep the build thin and light.
- Clear display window: A large cutout shows the full LCD without any bezel in the way.
- Control cutouts: Openings on the front plate leave the buttons and joystick area accessible.
- Ventilation slots: Slots on the back plate let heat escape from the Pi.
- Port access: A long side slot on the back plate leaves the header and connectors reachable.
- Tool-free to modify: Standard small screws mean you can reopen the case any time.
- Black hardware: The black standoffs, screws and spacers give a clean, consistent look.
What’s in the box
- 1x Front acrylic plate (display and control cutouts)
- 1x Back acrylic plate (vent slots and port slot)
- 4x Black hex standoffs
- 8x Black screws
- 4x Black spacers
The Raspberry Pi Zero W and Waveshare 1.3in LCD display are not included.
Assembly
- Peel the protective film off both acrylic plates.
- Mount the Waveshare 1.3in LCD onto the Pi Zero W.
- Fit the spacers and standoffs at the four corner holes.
- Place the front plate over the display and the back plate under the Pi.
- Fasten with the screws and tighten gently. Don’t overtighten, as acrylic can crack.
Compatibility
- Raspberry Pi Zero W (also fits Zero WH and Zero 2 W if the board layout matches: confirm before listing)
- Waveshare 1.3in LCD display module
Specifications
- Material: Laser-cut acrylic (add thickness)
- Hardware: Black hex standoffs, screws and spacers
- Dimensions: 7 x 3 x 1cm
- Weight: 15 grams
- Assembly: Screw-together, no adhesive
Notes
- The acrylic ships with a protective film, which is why it looks tan or brown in photos. Peel it off for a clear finish.
- Handle the plates by the edges to avoid fingerprints and scratches.