Navio2+ Autopilot HAT for Raspberry Pi powered by ArduPilot and ROS
Turn your Raspberry Pi® into a powerful drone controller with Navio2+, an autopilot HAT featuring onboard sensors, controllers, and a GNSS receiver.
Navio2+ builds on the proven Navio2 platform with an updated u-blox NEO-M9N GNSS receiver and a redesigned connector interface. A new wire pack is also available for purchase, providing convenient connectivity options for your setup.
Currently supported boards
ArduPilot on Navio2+ works on:
-
Raspberry Pi 4 Model B
-
Raspberry Pi 3 Model A+
-
Raspberry Pi 3 Model B
-
Raspberry Pi 3 Model B+
-
Raspberry Pi 2 Model B
NOTE: Other models such as Raspberry Pi Model A+, Raspberry Pi Model B+, and Raspberry Pi Zero are electrically compatible, but lack the performance required to run ArduPilot:Copter.
Features
-
GNSS receiver: u-blox NEO-M9N GNSS receiver with external antenna connection
-
RC I/O co-processor: Accepts PPM/SBUS input and provides 14 PWM output channels for motors and servos
-
Dual IMU: Accelerometers, gyroscopes and magnetometers for orientation and motion sensing
-
Triple redundant power supply: With overvoltage protection and power module port for voltage and current sensing
-
Extension ports: Exposed ADC, I2C and UART interfaces for sensors and radios
-
High resolution barometer: Senses altitude with 10 cm resolution
-
Redesigned connector: Updated connector design for the Navio2+ platform
-
Preconfigured OS image: A Raspbian-based image with ArduPilot and ROS preinstalled and ready to run with a couple of simple commands. Also comes with DroneKit and GStreamer
Technical Specifications
Mechanical
-
Dimensions: 55x6mm
-
Weight: 23g
-
Operating temperature: -40…+85 ºC
Electrical
-
Supply voltage: 4.75–5.25 V
-
Power supply: Power module, servo rail, USB
-
Average current consumption: 150 mA
Ports
-
Power module
-
UART
-
I2C
-
ADC
-
14 PWM servo outputs
-
PPM/S.Bus input
ICs
-
MPU9250 9DOF IMU
-
LSM9DS1 9DOF IMU
-
MS5611 barometer
-
u-blox NEO-M9N GNSS receiver
-
Cortex-M3 RC I/O co-processor
-
RGB LED
Includes
-
Navio2+
-
Connector for Raspberry Pi
-
4x spacers
-
8x M2.5 screws