One of the most common converter cables you'll want in your cable collection - this 32" long cable converts a standard 3.5mm stereo jack to pigtail wires. Ground ring is black, middle ring is white and tip is red. Cable is 32"/81cm long from end to end.

Listen up! This 3" diameter speaker cone is the perfect addition to any audio project where you need an 4 ohm impedance and 3W or less of power. We particularly like this cone as it has 4 handy mounting tabs 60mm apart. Works great with class D...

The Raspberry Pi has an on-board audio jack, which is super handy for all kinds of sound effects and speech, just plug and go! However, for when you want better audio for music playback, a USB audio card can greatly improve the sound quality and volume...

A mini class D with AGC and I2C control? Yes please! This incredibly small stereo amplifier is surprisingly powerful. It is able to deliver 2 x 2.8W channels into 4 ohm impedance speakers (@ 10% THD) and it has a i2c control interface as well as an AGC...

Pipe audio in or out of your project with this very handy breadboard-friendly audio jack. It's a stereo jack with disconnect-switches on Left and Right channels as well as a center ground pin. You can use any 3.5mm stereo cable with this jack. The pins...

  The HiFiBerry DAC+ is a high-resolution digital-to-analog converter for the Raspberry Pi. This is a special sound card for the Raspberry Pi, that is optimized for one specific use case: the best audio playback quality. Dedicated...

Description: Low profile 3.5mm stereo audio jack. Documents: Audio 3.5mm Jack Datasheet

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466, an op-amp specifically...

If you are looking for a case for HiFiBerry DAC+,Digi+ or AMP+ board - please check our own HighPi Case that was designed with HiFiBerry boards in mind. It's now in stock! The HiFiBerry Digi+ is a high-quality S/PDIF output board for the Raspberry Pi...

If you are looking for a case for HiFiBerry DAC+,Digi+ or AMP+ board - please check our own HighPi Case that was designed with HiFiBerry boards in mind. It's now in stock! The HiFiBerry DAC+ is a high-resolution digital-to-analog converter for the...