Categories - PiShop.ca

Sub Categories

Breadboard trim potentiometer - 10K

$1.95

These are our favorite trimpots, perfect for breadboarding and prototyping. They have a long grippy adjustment knob and with 0.1" spacing they plug into breadboards or perfboards with ease. This is the same pot that comes with our character LCDs and...

Add to Cart

Huge 6V 6W Solar panel - 6.0 Watt

$75.95 $99.95

These panels come to us from Voltaic Systems, makers of fine solar-powered bags and packs. These are waterproof, scratch resistant, and UV resistant. They use a high efficiency monocrystalline cell. They output 6V at 930 mA via 3.5mm x 1.1mm DC jack...

Notify Me

Adafruit Proto Shield for Arduino Kit - Stackable Version R3

$11.95 $13.95

This prototyping shield is the best out there (well, we think so, at least), and now is even better with Version R3 - updated for the most compatibility with just about all the Arduinos! It works with UNO, Mega, Leonardo, NG, Diecimila, Duemilanove,...

Add to Cart

Terminal Block - 3-pin 3.5mm - pack of 5

$5.45

Nothing makes a project harder to maintain than a lot of loose wiring. That's why we like to use terminal blocks whenever making PCB-to-Wire connections. These particular 3.5mm terminal blocks are our favorite: big enough for a range of wire gauges, easy...

Add to Cart

2.54mm/0.1" Pitch Terminal Block - 2-pin

$1.25 $1.45

After a long day out harvesting in the terminal block fields, we've returned with a veritable bounty of these very nice and compact 2.54mm/0.1" terminal blocks in a variety of sizes. Our harvest of terminal blocks is great news since nothing makes...

Add to Cart

Panel Mount 10K potentiometer (Breadboard Friendly) - 10K Linear

$1.45

This potentiometer is a two-in-one, good in a breadboard or with a panel. Its a fairly standard linear taper 10K ohm potentiometer, with a grippy shaft. Its smooth and easy to turn, but not so loose that it will shift on its own. We like this one because...

Add to Cart

Potentiometer Knob - Soft Touch T18 - Red

$1.95

Oh say can you see By the knob's early light... Sorry - we thought that was clever. And while it wasn't really, this potentiometer knob definitely is. It's a 'soft touch' T18 knob that works great with our Panel Mount 10K potentiometers...

Add to Cart

Raspberry Pi Model A+ Case Lid - Clear

$0.95 $1.95

This is just the clear lid of the Raspberry Pi Model A+ case. Check out our A+ base here. This enclosure was designed by Mike Doell. It's made of ultra-durable, super-glossy polycarbonate, and is both good looking and tough enough...

Notify Me

RPG - Proto - B+/Pi2B - BB

$8.95

Our own Raspberry PI Model B+/Pi2B GPIO board! This Raspberry PI GPIO board is ideal for converting a bread board design into something more permanent or just prototyping a new idea using familiar bread board style connections. For more experienced...

Notify Me

RPG - Proto - B+/Pi2B - Standard

$13.95

Notify Me

Long-Range 300Mbps Wireless-N Adapter

$16.95

The best one we have. Offers the best coverage and high data transfer speed. Works with Raspbian/OpenELEC "out of the box". - Chipset: Realtek 8192CU (HX9700) - WiFi: 2.4Ghz IEEE802.11b/g/n - USB 2.0 - Max. 300Mbps - WPS - 5dBi RP-SMA antenna - Access...

Notify Me

USB Battery Pack for Raspberry Pi - 10000mAh - 2 x 5V @ 2A

$54.95

A large-sized rechargeable battery pack for your Raspberry Pi (or Arduino, or Propeller, or anything else that uses 5V!). This pack is intended for providing a lot of power to an GPS, cell phone, tablet, etc but we found it does a really good job of...

Notify Me

Electret Microphone Amplifier - MAX4466 with Adjustable Gain

$11.95

Add an ear to your project with this well-designed electret microphone amplifier. This fully assembled and tested board comes with a 20-20KHz electret microphone soldered on. For the amplification, we use the Maxim MAX4466, an op-amp specifically...

Add to Cart

PiTFT - Assembled 480x320 3.5" TFT+Touchscreen for Raspberry Pi

$49.95

Is this not the cutest, little display for the Raspberry Pi? It features a 3.5" display with 480x320 16-bit color pixels and a resistive touch overlay so is slightly larger than Adafruit's popular original. The plate uses the high speed SPI interface on...

Notify Me

Wonder Workshop Accessory Pack

$34.95 $39.95

Give Dash & Dot new abilities and looks by adding accessories! This package includes a bulldozer bar to clean up those toys (for Dash only), bunny ears, a bunny tail and a tow hook. In addition, for a limited time, the Smartphone Mount is being...

Notify Me

Wonder Workshop Building Brick Connectors

$14.95 $21.95

Dash & Dot can use building brick connectors to play with your existing toys! They are compatible with Lego® bricks, Technics, Mindstorms kits and Hero Factory. Each pack comes with 4 connectors. To transform Dash and Dot into anything you can...

Notify Me

Wonder Workshop Dash's Xylophone

$49.95

Everything you need to turn Dash into a Beethoven while you learn to program with music. Mallet accessory included.

Notify Me

Wonder Workshop Music Pack

$0.00

THIS ITEM IS NO LONGER AVAILABLE If your child has a creative streak and loves to sing or play instruments, this pack is for you. Create your own one-robot marching band with the music pack. This pack includes Dash and the xylophone accessory.

Notify Me

Wonder Workshop Dash & Dot Robot Wonder Pack

$0.00

THIS ITEM IS NO LONGER AVAILABLE Wonder Workshop Dash & Dot Wonder Pack Discover a new world of play and learning Kids define how they want to play. Whether you're into hosting make-believe tea parties, having jousts at magical kingdoms, or...

Notify Me

Wonder Workshop Dash and Dot Robot Pack

$0.00

Wonder Workshop Dash and Dot Pack Discover a new world of play and learning Kids define how they want to play. Whether you're into hosting make-believe tea parties, having jousts at magical kingdoms, or adventuring with friends, Dash & Dot will be...

Notify Me