other

Description: High quality general purpose PCB. Material: Single Side Copper PCB. Hole Dia: about 1mm. Hole pitch: standard 2.54mm. For point to point DIY soldering. Size:5cm x 7cm - 1.97inch x 2...

The Raspberry Pi has an on-board audio jack, which is super handy for all kinds of sound effects and speech, just plug and go! However, for when you want better audio for music playback, a USB audio...

HDMI Male to Male Flat Cable, Nickel Plated, 0.3 meter Connect two HDMI devices together and save space with this basic flat HDMI 1.4 cable. It has nice molded grips for easy installation, and is 1...

5V Four Channel SSR Solid Relay Module 240V / 2A - High Level Trigger - For Arduino Specifications Max. LoadAC: 240V Input Voltage: 5V DC Trigger Current: 2mA Dimensions: 2.28 in x 2.2 in x 0.94 in...

This is a 5V 8-Channel Relay interface board able to control various appliances, and other equipment with large currents. It can be controlled directly by Micro-controller (Raspberry Pi, Arduino,etc...

"These go to eleven."  11 millimeters that is! Our Black Plated M/F Brass Standoffs are engineered specifically to keep your Pi HAT snug on your Pi while also keeping the two...

WARNING: This adapter requires installation of a third-party driver. Although it is relatively simple, PLEASE READ THE INSTALLATION INSTRUCTIONS and ensure you are comfortable following them...

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size. Works great, just carefully open the connector on...

Heatsink 1: Size: 14 x 14 x 6mm Baseboard thickness: 1.0mm Fin thickness: 0.7mm Fin number: 7 pieces Fin space width: 1.5mm Heatsink 2: Size: 9 x 9 x 4mm Baseboard thickness: 1.0mm Fin...

  One Terminal Strip, Tie-point 25. Material: ABS plastic Completely reusable. Accepts a variety of wire sizes (29-20 AWG)...

40 pin cable, 30cm in length. Cable type: female-female

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size. Works great, just carefully open the connector on...

Current Limiting resistor IMΩ +/- 5% Electro-scattering time 0.1 sec Safe and reliable Adjustable at will Rinsing resisting Suitable for use in clean rooms

This inexpensive USB to RS232 cable works well for Linux and Windows 7 environments, but is not currently functioning with Windows 10. Suitable for link download Simple and easy way to give USB...

This is a 5V, 10A 2-Channel Relay interface board. It can be used to control various appliances, and other equipments with large current. It can be controlled directly with 3.3V or 5V logic signals...

We use these sets of 4 clear rubber feet on our HighPi case, but you'll find other uses for them too! 

Adhesive thermal layer Keep your Raspberry Pi cool with this heat sink Reduces the risk of hardware failure due to overheating Low profile, will fit into most cases Simple, passive cooling. no...

Mini 170 Tie Points Prototype Solderless Breadboard With self-adhesive tape Suitable for electronic circuit assembly / debugging / training A magic combination breadboard pattern of isolated tie...

PRO SIGNAL-RPUSB 1M-COMPUTER CABLE, USB A PLUG TO MICRO USB B PLUG, 1M, BLACK High quality standard A-miniB USB cable, for USB 1.1 or 2.0. Approximately 1M (3ft) long from end to end.